- Feature History
- Using Cisco IOS XE Software
- Console Port Telnet and SSH Handling
- Configuring the Route Switch Processor
- Configuring Ethernet Interfaces
- Using the Management Ethernet Interface
- Configuring T1/E1 Interfaces
- Configuring Optical Interface Modules
- Configuring Serial Interfaces
- Enabling Support for Tunable DWDM-XFP-C
- Dying Gasp Support for Loss of Power Supply via SNMP, Syslog and Ethernet OAM
- Configuring Pseudowire
- Digital Optical Monitoring for Transceivers
- Configuring the SDM Template
- BCP Support on MLPPP
- Tracing and Trace Management
- Configuring and Monitoring Alarm
- OTN Wrapper Overview
- Using Zero Touch Provisioning
- Configuring 1G Traffic on 8-port 10 Gigabit Ethernet Interface Module
- Configuring 8/16-port 1 Gigabit Ethernet (SFP / SFP) + 1-port 10 Gigabit Ethernet (SFP+) / 2-port 1 Gigabit Ethernet (CSFP) Interface Module
Feature History
The following table lists the new and modified features supported in the Cisco ASR 900 Router Series Configuration Guide in Cisco IOS XE 16 releases.
|
Feature Name |
Cisco IOS XE Release |
|---|---|
|
RS232 Async with E2E Signaling Support |
16.11.1a |
|
Video Template - IPv4 QoS classifications |
|
|
SDM template enhancement for uRPF scale |
16.9.4 |
|
Dying Gasp via SNMP Trap |
16.9.1a |
|
IPv6 Qos ACL L4 classification with expansion approach on IPv6 QoS SDM Template |
|
|
RS232 Sync |
|
|
Over Subscription Mode and Partial Port Mode Support on 8-port 10 Gigabit Ethernet Interface Module on the ASR 907 Chassis |
|
|
IPv6 QoS support for SDM Template |
16.8.1 |
|
AIS Coreflap |
16.7.1 |
|
Card Protection for 48-port T1/E1 CEM Interface Module and 48-port T3/E3 CEM Interface Module |
16.6.3 |
|
Alarm support for 900W |
16.6.1 |
|
DS1 and DS3 Card Protection |
|
|
BCP Support on MLPPP |
16.5.1 |
|
Configuring 1G Mode on 8-port 10 Gigabit Ethernet Interface Module |
|
|
Configuring Unidirectional Path Switching Ring (UPSR) |
|
|
OTN Wrapper |
|
|
SSM Support on Cisco 48 X T3/E3 CEM Interface Module |
Feedback