- Feature History
- Using Ethernet Operations Administration and Maintenance
- Trunk EFP Support
- Ethernet Virtual Connections Configuration
- EVC Local Connect
- Using Ethernet Fault Detection
- Configuring Ethernet Connectivity Fault Management in a Service Provider Network
- Transparent CFM
- VLAN Translation with QoS
- G.8032 and CFM Support for Microwave Adaptive Bandwidth
- Microwave ACM Signaling Configuration and EEM Integration
- Configuring Ethernet Local Management Interface at a Provider Edge
- ITU-T Y.1731 Performance Monitoring in a Service Provider Network
- Using Link Layer Discovery Protocol in Multivendor Networks
- Configuring Switched Port Analyzer
- Configuring IEEE 802.1ad
- Feature Overview
- Configuring Latching Loopback
Feature History
The following table lists the new and modified features supported in the Carrier Ethernet Configuration Guide in Cisco IOS XE 17 releases.
| Feature | Description |
|---|---|
|
Cisco IOS XE Dublin 17.10.1 |
|
|
Tagged Packet Support Using Link Layer Discovery Protocol (LLDP) |
LLDP now supports tagged packet transmission over a service instance with dot1q encapsulation. LLDP advertises information about themselves to their network neighbors, and store the information they discover from other devices. Though both these transmitted frames go through the same physical interface, they can be uniquely identified by the information advertised in the Port ID Type-Length-Value (TLV). You can use the lldp enable command to enable LLDP over a particular service instance. Use the show lldp neighbors and show lldp entry command outputs for neighboring device details. |
|
Cisco IOS XE Bengaluru 17.5.1 |
|
|
This feature enables for effective CPU utilization by offloading the one second CCM interval sessions on the hardware. |
|
|
Cisco IOS XE Bengaluru 17.4.1 |
|
|
You can configure the platform bdi enable-state up global command. |
|
Feedback