Cisco IOS XE 17.13.1
|
Out-of-order Packet Counter on the Cisco RSP3 Module
|
You can configure Out-of-order packet counter for FPGA-based SAT on the Cisco RSP3 module.
|
Cisco IOS XE Dublin 17.10.1
|
SADT over VC when Access Interface is Down
|
You can perform Service Activation and Deactivation (SADT) over Virtual Circuit (VC) even when access interface is down.
|
Cisco IOS XE Bengaluru 17.5.1
|
TWAMP Light
|
This feature enables you to configure a TWAMP Light session using the ip sla responder twamp-light test-session command on the Cisco RSP2 module.
|
Cisco IOS XE Bengaluru 17.4.1
|
Configurable User-Defined and EMIX Packet Size
|
This feature allows you to configure user-defined and Enterprise traffic (EMIX) packet sizes. Use the following commands to
configure user-defined and EMIX packet sizes:
|
SAT based support for configurable EMIX traffic pattern in FPGA
|
The support for EMIX packet size is enhanced. For EMIX traffic, packet sizes of 64, 128, 256, 512, 1024, 1280, 1518, Maximum
Transmission Unit (MTU) and user-defined patterns are supported. These packet sizes are forwarded in ratio of 1:1:1:1:1.
|
Cisco IOS XE Amsterdam 17.3.1
|
Configurable Y.1564 Service Activation Frame Sizes and EMIX Support
|
Enterprise traffic (EMIX) packet size (default abceg pattern) is supported on both, Cisco ASR 900 RSP2 and RSP3 modules. For
EMIX traffic, ITU-T Rec. Y.1564 packet sizes of 64, 128, 256, 1024, and 1518 bytes are supported. On the Cisco RSP3 module,
it is supported in FPGA-based SADT.
|