Framed SAToP System BERT

You can configure SATOP system BERT with framing under CEM circuits on T1 or E1 interfaces and verify if the BERT is stable and transmitted end-to-end.

MFR End-to-End Mode

This feature enables transporting legacy MFR traffic over packet switching core.

You can now configure an end-to-end mode for frame relay pseudowire on the MFR interfaces for the following interface modules:

• A900-IMA3G-IMSG

• A900-IMA1Z8S-CXMS

User-defined Remote Loopback on T1 Interfaces

You can customize the loopback codes on T1 in a 16-bit format in contrast to the standard 6-bit loop code on the 48-port T1 interface module.

Out-of-order Packet Counter on the Cisco RSP3 Module

You can configure Out-of-order packet counter for FPGA-based SAT on the Cisco RSP3 module.