Switch Settings
The Switch option from the Cisco Enterprise NFVIS portal allows you to configure STP/RSTP, VLAN on specified ranges, RADIUS based authentication, and port channel load balancing for various switch ports. This section describes how to configure settings on the ENCS switch portal.
![](/c/dam/en/us/td/i/300001-400000/360001-370000/366001-367000/366822.jpg)
![](/c/dam/en/us/td/i/300001-400000/360001-370000/366001-367000/366823.jpg)
You can view the Switch Interface operational data and the statistics parameters in the following table:
Parameter |
Description |
Values |
SwitchPort |
Specifies the switch interface name. |
|
Description |
Specifies the description of the interface. |
|
Status |
Specifies the status of the interface. |
up or down |
MAC Address |
Specifies the MAC address of the interface. |
|
PortType |
Specifies the mode of the port interface. |
Supported types are:
|
VLAN |
Specifies the VLAN ID. |
Range: 1-2349 and 2450-4093 |
Speed |
Specifies the speed of the interface. |
Speed:
|
RxBytes |
Specifies the received data on interface in bytes. |
|
PktDrop |
Specifies the number of packet drops. |
|
PORT |
Specifies the port number. |
|
IN-UCAST |
Specifies the number of incoming unicast packets at the interface. |
|
OUT-UCAST |
Specifies the number of outgoing unicast packets at the interface. |
|
IN-MCAST |
Specifies the number of incoming multicast packets at the interface. |
|
OUT-MCAST |
Specifies the number of outgoing multicast packets at the interface. |
|
IN-BCAST |
Specifies the number of incoming broadcast packets at the interface. |
|
OUT-BCAST |
Specifies the number of outgoing broadcast packets at the interface. |