Architecture with a Global Center
Update the Global Center
In the case of a distributed architecture, you must first update the Global Center, then its Centers.
Procedure
Step 1 |
You can do so through the corresponding Center's Cisco Cyber Vision application or using its Command Line Interface. |
Step 2 |
To update the Global Center: |
Step 3 |
Through the Cisco Cyber Vision application: |
-
File= CiscoCyberVision-update-combined-<VERSION>.dat
-
Navigate to Admin > System, click the System Update button, and browse to select the update file.
Step 4 |
Through the Command Line Interface (CLI): |
-
File= CiscoCyberVision-update-center-<VERSION>.dat
-
Launch the update using the following command:
sbs-update install /data/tmp/CiscoCyberVision-update-center-<VERSION>.dat
Step 5 |
To update the Centers: |
Step 6 |
Connect to the Centers Cisco Cyber Vision application or CLI and repeat the same procedure used to update the Global Center. |
Update the sensors
The update of the sensors is done from their corresponding Center (not from the Global Center). You must repeat the following procedures from each of your Centers to cover all sensors of your industrial network. Procedures differ between hardware sensors and IOx sensors.
Procedure
Step 1 |
To update hardware sensors: |
Step 2 |
If you used the combined file to update the Center which owned the sensor, the hardware sensors (IC3000 and Sentryo Sensors) were updated at the same time. |
Step 3 |
If not, the update needs to be done from the Command Line Interface (CLI): |
-
File= CiscoCyberVision-update-sensor-<VERSION>.dat
-
Launch the update using the following command:
sbs-update install /data/tmp/CiscoCyberVision-update-sensor-<VERSION>.dat
Step 4 |
To update IOx sensors: |
Step 5 |
If you have installed the sensor with the sensor management extension, the upgrade of the extension will also update all sensors reachable by the Center. |
-
File = CiscoCyberVision-sensor-management-<VERSION>.ext
-
Navigate to Admin > Extensions. In the Actions column, click the Update button, and browse to select the update file.
Step 6 |
If one or several sensors were not updated by the extension update, navigate to Admin > Sensors > Sensors and click the UPDATE CISCO DEVICES button to update the remaining IOx sensors connected to the Center. |
Step 7 |
If you have not installed one or several sensors with the sensor management extension, you can upgrade them with the sensor package from the platform's local manager or from the platform's Command Line Interface. This procedure is detailed in the corresponding sensor installation guide. |
Step 8 |
|