Configure Interfaces
When you use zero-touch provisioning or the device manager for initial setup, the following interfaces are preconfigured:
-
Ethernet 1/1—outside, IP address from DHCP, IPv6 autoconfiguration
-
Ethernet 1/2— inside, 192.168.95.1/24
-
Default route—Obtained through DHCP on the outside interface
If you performed additional interface-specific configuration within device manager before registering with the management center, then that configuration is preserved.
The following example configures a routed-mode inside interface with a static address and a routed-mode outside interface using DHCP. It also adds a DMZ interface for an internal web server.
Procedure
Step 1 |
Choose Edit () for the firewall. , and click |
Step 2 |
Click Interfaces. |
Step 3 |
Click Edit () for the interface that you want to use for inside. |
Step 4 |
Click Edit () for the interface that you want to use for outside. |
Step 5 |
Configure a DMZ interface to host a web server, for example. |
Step 6 |
Click Save. |