Skip to content
Skip to search
Skip to footer

Cisco Nexus 3000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: September 2, 2015

Chapter: New and Changed Information

New and Changed Information
New and Changed Information

New and Changed Information

This chapter contains the following sections:

New and Changed Information

This chapter contains the following sections:

Table 1. New and Changed Features
Feature	Description	Added or Changed in Release	Where Documented
Supports show lldp neighbors and show cdp neighbors commands	Added support for show lldp neighbors and show cdp neighbors commands.	7.0(3)I7(4)	Information About Global LLDP Commands
MAC address tables	Added support for disabling and re-enabling MAC address learning on Layer 2 interfaces.	7.0(3)I7(4)	Guidelines for Configuring the MAC Address Tables Configuring MAC Move Loop Detection Disabling MAC Address Learning on Layer 2 Interfaces
VLAN Mapping for Selective Q-in-Q	Added support for all the VLAN IDs (C-VLAN) entering the switch from the customer network	7.0(3)I6(1)	Configuring VLAN Mapping for Selective Q-in-Q on a Private VLAN Secondary Trunk Port
Configuring VLAN Mapping for Selective Q-in-Q on a Private VLAN Secondary Trunk Port	Added support for configuring VLAN mapping for selective Q-in-Q on a private VLAN secondary trunk port.	7.0(3)I5(2)	Configuring VLAN Mapping for Selective Q-in-Q on a Private VLAN Secondary Trunk Port
Private VLAN Support	Added support for PVLAN Isolated Trunk Port and Promiscuous Trunk Port.	7.0(3)I5(1)	Configuring a Layer 2 Interface as a Private VLAN Isolated Trunk Port Configuring a Layer 2 Interface as a Private VLAN Promiscuous Trunk Port
The aging of the mac-address is not incrementing in the output of the show mac address-table command.	The aging of the mac-address is not incrementing in the output of the show mac address-table CLI command.	7.0(3)I2(1)	Guidelines for Configuring the MAC Address Tables Configuring the Aging Time for the MAC Table
Using the show system internal ip igmp snooping module CLI command or the show mac address-table multicast CLI command to check the Layer 2 entries.	The show mac address-table CLI command does not display the multicast MAC entries. Use the show system internal ip igmp snooping module CLI command or the show mac address-table multicast CLI command to check the Layer 2 entries.	7.0(3)I2(1)	Guidelines for Configuring the MAC Address Tables
The output of show running-config vlan displays redundant entries of VLAN.	The output of show running-config vlan displays multiple entries of the VLAN output. There is no functional impact of this behavior change.	7.0(3)I2(1)	Verifying the VLAN Configuration

Was this Document Helpful?

Feedback

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)