- Preface
- New and Changed Information
- Layer 3 Interfaces Commands
- H Commands
- I Commands
- N Commands
- IGMP Commands
- C Commands
- I Commands
- Show Commands
- IGMP Snooping Commands
- C Commands
- H Commands
- I Commands
- Show Commands
- MSDP Commands
- C Commands
- F Commands
- I Commands
- R Commands
- Show Commands
- PIM Commands
- C Commands
- F Commands
- I Commands
- R Commands
- Show Commands
H Commands
This chapter describes the Cisco NX-OS IGMP snooping commands that begin with H.
hardware multicast snooping group-limit
To configure the number of groups learned through IGMP Snooping, use the hardware multicast snooping group-limit command.
hardware multicast snooping group-limit limit
Syntax Description
Number of groups learned through IGMP Snooping. The range is from 100 to 8000. |
Command Default
Command Modes
Command History
|
|
Usage Guidelines
Before setting a new group-limit, you must either clear the MAC address table or clear the groups already learned.
The unique OIFL (output interface list) combinations can only be 2000.
Use the vPC type-2 inconsistency to show the configuraitons on vPC peers.
A reload is not neccessary after configuring the group-limit.
Examples
This example shows how to set the maximum number of groups to 500:
switch(config)#
hardware multicast snooping group-limit 500
Related Commands
|
|
---|---|
Displays information about the group membership for IGMP snooping. |
Usage Guidelines
Examples
This example shows how to clear the explicit tracking information for VLAN 1:
switch#
clear ip igmp snooping explicit-tracking vlan 1
switch#
Related Commands
|
|
---|---|