errdisable detect cause
To enable error-disable (err-disabled) detection in an application, use the errdisable detect cause command. To disable error disable detection, use the no form of this command.
errdisable detect cause {all | link-flap | loopback}
no errdisable detect cause {all | link-flap | loopback}
Syntax Description
all |
Enables error detection on all cases. |
link-flap |
Enables error disable detection on linkstate-flapping. |
loopback |
Enables error disable detection on loopback. |
Command Default
Enabled
Command Modes
Global configuration mode
Command History
Release |
Modification |
---|---|
4.2(1)N1(1) |
This command was introduced. |
Usage Guidelines
When error disable detection is enabled and a cause is detected on an interface, the interface is placed in an err-disabled state, which is an operational state that is similar to the link-down state.
Examples
This example shows how to enable the err-disabled detection on linkstate-flapping:
switch(config)# errdisable detect cause link-flap
switch(config)#