R Commands
This chapter describes the Cisco NX-OS interface commands that begin with R.
rate-limit cpu direction
To set the packet per second (PPS) rate limit for an interface, use the rate-limit cpu direction command. To revert ot the default value, use the no form of this command.
rate-limit cpu direction { both | input | output } pps pps_value action log
no rate-limit cpu direction { both | input | output } pps pps_value action log
Syntax Description
Specifies the packets per second. The range is from 0 to 100,000. |
|
Writes a syslog message if the PPS value matches or exceeds the specified rate limit. |
Command Default
Command Modes
Command History
|
|
---|---|
Usage Guidelines
Examples
This example shows how to set the maximum input packet rate to 3 for an interface and enable the logging of syslog messages:
Related Commands
|
|
---|---|
Related Commands
|
|
---|---|
Configures the virtual routing and forwarding (VRF) instance for a remote machine. |
|
resync-database
To resynchronize the switch profile databases, use the resync-database command.
Syntax Description
Command Default
Command Modes
Switch profile configuration mode
Command History
|
|
---|---|
Examples
This example shows how to resynchronize the switch profile databases:
Related Commands
|
|
---|---|