no switchport
To configure the interface as a Layer 3 Ethernet interface, use the no switchport command.
no switchport
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Interface configuration mode
Command History
|
Release |
Modification |
|---|---|
|
5.2(1)N1(1) |
This command was introduced. |
Usage Guidelines
You can configure any Ethernet port as a routed interface. When you configure an interface as a Layer 3 interface, any configuration specific to Layer 2 on this interface is deleted.
If you want to configure a Layer 3 interface for Layer 2, enter the switchport command. Then, if you change a Layer 2 interface to a routed interface, enter the no switchport command.
Examples
This example shows how to enable an interface as a Layer 3 routed interface:
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)#
This example shows how to configure a Layer 3 interface as a Layer 2 interface:
switch(config)# interface ethernet 1/5
switch(config-if)# switchport
switch(config-if)#
Feedback