The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS sysmtem managementcommands that begin with E.
To configure the flow ID for an Encapsulated Remote Switched Port Analyzer (ERSPAN) session, use the erspan-id command. To remove the flow ID, use the no form of this command.
ERSPAN source session configuration mode (config-erspan-src)
ERSPAN destination session configuration mode (config-erspan-dst)
SPAN-on-Drop ERSPAN session configuration mode (config-span-on-drop-erspan)
SPAN-on-Latency ERSPAN session configuration mode (config-span-on-latency-erspan)
This example shows how to configure the flow ID for an ERSPAN source session:
This example shows how to configure the flow ID for an ERSPAN destination session:
This example shows how to configure the flow ID for a SPAN-on-Drop ERSPAN session:
This example shows how to configure the flow ID for a SPAN-on-Latency ERSPAN session:
To specify a NetFlow exporter to use for a NetFlow monitor, use the exporter command. To remove a NetFlow exporter, use the no form of this command.
NetFlow monitor configuration (config-flow-monitor)
|
|
This example shows how to configure a NetFlow exporter for a NetFlow monitor:
This example shows how to remove a NetFlow exporter:
|
|
---|---|