Technical Specifications of the Cisco IP 7960G/7940G Phone
This appendix contains the following sections:
•
Physical and Operating Environment Specifications
•
Cable Specifications
•
Regulatory Safety Compliance
•
Connection Specifications
Physical and Operating Environment Specifications
Table A-1 lists the physical and operating specifications of the Cisco IP 7960G/7940G phone.
Table A-1 Cisco IP 7960G/7940G Phone Specifications
|
|
Operating temperature |
32 to 104°F (0 to 40°C). |
Operating relative humidity |
10 to 95% (noncondensing). |
Storage temperature |
14 to 140°F (-10 to 60°C). |
Height |
8 in. (20.32 cm). |
Width |
10.5 in. (26.67 cm). |
Depth |
6 in. (15.24 cm). |
Weight |
3.5 lb (1.6 kg). |
Power |
100 to 240 VAC, 50 to 60 Hz, 0.5 A—when using the AC adapter. 48 VDC, 0.2 A—when using the inline power over the network cable. |
Cables |
Two pair of Category 3 cables for 10 Mbps. Two pair of Category 5 cables for 100 Mbps. |
Distance requirements |
As supported by the Ethernet specification, it is assumed that most phones that are deployed in the field are within 330 ft (100 m) of a phone closet. |
Cable Specifications
The following cables are required to connect the Cisco IP 7960G/7940G phone:
•
RJ-11 for the handset connection.
•
RJ-45 jack for the LAN connection (labeled "10/100 SW").
•
RJ-45 jack for a second 10BASE-T compliant connection (labeled "10/100 PC").
•
48-volt power connector. The diameter of the center pin in the phone power jack (Switchcraft 712A) is 0.1 inches (2.5 mm). The center pin is positive (+) voltage. The miniature power plug required to mate with the power jack on the phone is a Switchcraft 760 or equivalent.
Regulatory Safety Compliance
For international agency compliance, safety, and statutory information on Cisco IP phone models in the 7900 series, refer to Regulatory Compliance and Safety Information for the Cisco IP Phone 7900 Series at http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/ipp7960/iphrcsi3.htm.
Connection Specifications
The Cisco IP 7960G/7940G phone has two RJ-45 ports that each support 10/100 Mbps half- or full-duplex connections to external devices—the network port and the access port. You can use either Category 3 or Category 5 cabling for 10-Mbps connections, but use Category 5 for 100-Mbps connections. On both the LAN-to-phone port (left RJ-45 port facing the back of the phone) and the PC-to-phone port (right port), use full-duplex to avoid collisions. Use the LAN-to-phone port to connect the phone to the network. Use the PC-to-phone port to connect a network device, such as a computer, to the phone.
For a diagram the identifies the different ports on the back of the phone, see the "Cisco IP 7960G/7940G Phone Overview" section on page 1-2.