Locating LEDs and Components
The panel layouts for this appliance are described in:
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
The panel layouts for this appliance are described in:
The various LED states are defined in the Cisco UCS C220 M5 Server Installation and Service Guide at https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C220M5/install/C220M5.html
The Cisco Expressway CE1200 appliance comes pre-installed with an SD card that you can use to complete a reinstall of your configuration. You must reset the SD card and enable the virtual drive before proceeding with the reinstall using the KVM console in the Cisco Integrated Management Controller (CIMC). Once the reset is complete, make sure that you disable the virtual drive again.
You need to set up and access the CIMC, as described in Run the Install Wizard.
Step 1 |
Log in to the CIMC. |
Step 2 |
Click the menu arrow in the top left corner and navigate to . |
Step 3 |
Under the General tab, click Activate/Reset FlexFlash Controller and click ok in the popup window that appears. The reset ensures your FlexFlash Controller is in the correct state. |
Step 4 |
Click the Virtual Drives tab. |
Step 5 |
Check the Hypervisor checkbox. |
Step 6 |
Click Enable Virtual Drive and confirm that you would like to enable the virtual drive. |
Step 1 |
Launch the KVM Console using the icon in the CIMC. |
Step 2 |
Power up the CE1200 and, when prompted, press |
Step 3 |
Select |
Step 4 |
When prompted, press |
Step 5 |
Select |
Step 6 |
When prompted, type |
Step 7 |
Type During this reboot we recommend disabling the virtual drive (although you can also do it later as described in Task 3 below). To disable the virtual drive now:
|
Step 8 |
After the reboot completes, connect using serial to complete the reset. You will see the factory installation wizard. |
Step 9 |
You can optionally apply any option keys for the appliance (such as room or desktop registrations). If you choose not to at this stage, they can be applied later through the Expressway web UI or CLI. |
Step 10 |
When prompted, press The factory installation wizard phase is complete. |
Step 11 |
Power on the appliance, and follow the steps in Run the Install Wizard to complete the customer installation wizard. |
Step 1 |
Access the CIMC interface. |
Step 2 |
Go to tab. |
Step 3 |
Check the Hypervisor checkbox, then press Disable. |
Step 1 |
Log in to the CIMC (see Connecting Using CIMC Serial Over LAN). |
Step 2 |
Click the menu arrow in the top-left corner. |
Step 3 |
Go to . |
Step 4 |
Click Disable Power Characterization. |
Step 5 |
Click Save Changes. |