The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This guide is for the networking professional using the Cisco IOS command-line interface (CLI) to manage autonomous Cisco Aironet access points and bridges that run Cisco IOS software. Before using this guide, you should have experience working with Cisco IOS commands and access point and bridge software features.You also need to be familiar with the concepts and terminology of Ethernet and local area networking.
This guide provides information about new and revised Cisco IOS commands. For information about the standard Cisco IOS commands, refer to the IOS documentation set available from the Cisco.com home page at:
http://www.cisco.com/en/US/products/ps6350/tsd_products_support_series_home.html
This guide is organized into these sections:
“Using the Command-Line Interface,” describes how to access the command modes and use the command-line interface (CLI) to configure software features.
“Cisco IOS Commands for Access Points and Bridges,” describes in alphabetical order the Cisco IOS commands that you use to configure and monitor your access point or bridge.
Appendix A, “List of Supported Cisco IOS Commands,” lists the Cisco IOS commands that access points and bridges support. Cisco IOS commands that are not in this list have not been tested on access points and bridges and might not be supported.
This publication uses these conventions to convey instructions and information:
Command descriptions use these conventions:
Notes, cautions, and warnings use these conventions and symbols:
Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in this manual.
Warning The warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents.
For complete documentation for the supported access points, go to the following Cisco.com URL and browse to the access point’s page:
http://www.cisco.com/cisco/web/support/index.html
Documentation for the supported access points is also available from the access point’s Support page on Cisco.com. These documents include:
For information on obtaining documentation, obtaining support, providing documentation feedback, security guidelines, and also recommended aliases and general Cisco documents, see the monthly What’s New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html