Plugin Configuration Mode Commands

You enter this mode using the plugin command in the Global Configuration mode.

Mode

This chapter describes the commands available in the Plugin Configuration Mode. This mode is associated with the Dynamic Software Upgrade (DSU) process described in the System Administration Guide.

Exec > Global Configuration > Plugin Configuration

configure > plugin plugin_name

Entering the above command sequence results in the following prompt: 

[context_name]host_name(config-plugin-plugin_name)#

Important

The commands or keywords/variables that are available are dependent on platform type, product version, and installed license(s).

attribute

This command is not supported in this release.

Product

All

Privilege

Security Administrator, Administrator

Mode

Exec > Global Configuration > Plugin Configuration

configure > plugin plugin_name

Entering the above command sequence results in the following prompt: 

[context_name]host_name(config-plugin-plugin_name)#

Syntax

attribute  attribute_name attribute_value

Usage Guidelines

The command is not supported in this release.

do show

Executes all show commands while in Configuration mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

do show

Usage Guidelines

Use this command to run all Exec mode show commands while in Configuration mode. It is not necessary to exit the Config mode to run a show command.

The pipe character | is only available if the command is valid in the Exec mode.


Caution

There are some Exec mode show commands which are too resource intensive to run from Config mode. These include: do show support collection , do show support details , do show support record and do show support summary . If there is a restriction on a specific show command, the following error message is displayed: 

Failure: Cannot execute 'do	show support' command from Config mode.

end

Exits the current configuration mode and returns to the Exec mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

end

Usage Guidelines

Use this command to return to the Exec mode.

exit

Exits the current mode and returns to the parent configuration mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

exit

Usage Guidelines

Use this command to return to the parent configuration mode.

module priority

Configures the priority in the Version Priority List (VPL) for a specified version of a plugin module.

Product

ADC

Privilege

Security Administrator, Administrator

Mode

Exec > Global Configuration > Plugin Configuration

configure > plugin plugin_name

Entering the above command sequence results in the following prompt: 

[context_name]host_name(config-plugin-plugin_name)#

Syntax

module priority  number version  plugin_version attribute  attribute_name attribute_value 
no module priority  number

no

Removes the configured priority in the module priority list.

priority number

Specifies the priority of the plugin module as an integer from 1 through 100. Priority "1" has the highest priority.

version plugin_version

Specifies the version number of the plugin module. The version number is derived from the filename of the downloaded plugin.

attribute attribute_name attribute_value

Specifies an attribute value pair.

attribute_name specifies the name of an attribute value pair as an alphanumeric string from 1 through 255 characters.

attribute_value specifies the value of an attribute value pair as an alphanumeric string from 1 through 255 characters.

Usage Guidelines

Assign a priority number to a specific version of patch for the corresponding plugin. The priority number in the module priority list determines which version will be loaded when the update module command is used.

The show plugin command displays the VPL configuration status of this plugin module.

Example

The following command sets the priority of p2p plugin module version 1.17.4340 to 2 where the filename was libp2p-1.2.0.so.tgz: 
   module priority 2 version 1.2.0