threshold poll 10sec-cpu-utilization interval
Configures the polling interval over which to measure a 10-second average of CPU utilization.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll 10sec-cpu-utilization interval duration
default threshold poll 10sec-cpu-utilization interval
default
Restores the specified parameter to its default value 300 seconds.
interval duration
Default: 300 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
duration is an integer from 30 through 60000 in multiples of 30.
Usage Guidelines
This command sets the time period over which to monitor the specified value for threshold crossing.
Important |
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds. |
Refer to the threshold monitoring and other threshold commands for additional information on the system's support for thresholds in this chapter.
Important |
To enable an SNMP trap for monitoring this threshold use the snmp trap enable ThreshCPUUtilization10Sec command in this mode. |
Example
threshold poll 10sec-cpu-utilization 600