end
Exits the current configuration mode and returns to the Exec mode.
Product
All
Privilege
Security Administrator, Administrator
Syntax
end
Usage Guidelines
Use this command to return to the Exec mode.
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
The IPNE Service Configuration Mode is used to configure and manage the IPNE Service.
Exec > Global Configuration > Context Configuration > IPNE Service Configuration
configure > context context_name > ipne-service ipne_service_name
Entering the above command sequence results in the following prompt:
[ context_name]host_name (config-ipne-service)#
Important |
The commands or keywords/variables that are available are dependent on platform type, product version, and installed license(s). |
Exits the current configuration mode and returns to the Exec mode.
All
Security Administrator, Administrator
end
Use this command to return to the Exec mode.
Exits the current mode and returns to the parent configuration mode.
All
Security Administrator, Administrator
exit
Use this command to return to the parent configuration mode.
Creates and configures an IPNE endpoint and enters the IPNE endpoint configuration mode. An IPNE endpoint is a combination of a local IPP address, a peer address and, optionally, a port.
MME
Security Administrator, Administrator
Exec > Global Configuration > Context Configuration > IPNE Service Configuration
configure > context context_name > ipne-service ipne_service_name
Entering the above command sequence results in the following prompt:
[ context_name]host_name (config-ipne-service)#
[ no ] ipne-endpoint
Causes the system to delete the IPNE endpoint configuration from the IPNE service configuration.
Use this command to create an IPNE endpoint and to enter the IPNE endpoint sub-configuration mode.
ipne-endpoint