Manufacturers Federal Communication Commission Declaration of Conformity Statement
![](/c/dam/en/us/td/i/100001-200000/120001-130000/121001-122000/121808.ps/_jcr_content/renditions/121808.jpg)
Cisco Beacon Point Models |
Certification Number |
---|---|
Cisco Beacon Point |
LDK102111 |
Manufacturer:
Cisco Systems, Inc.
170 West Tasman Drive San Jose, CA 95134-1706 USA
This device complies with Part 15 rules. Operation is subject to the following two conditions:
-
This device may not cause harmful interference, and
-
This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna
-
Increase separation between the equipment and receiver.
-
Connect the equipment to an outlet on a circuit different from which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Cisco may void the user’s authority to operate the equipment
![]() Caution |
The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency when using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could void the user’s authority to operate this device. |