config radius acct
To configure settings for a RADIUS accounting server for the Cisco wireless LAN controller, use the config radius acct command.
config radius acct{ { add index IP addr port { ascii | hex} secret} | delete index | disable index | enable index | disable index | enable index | { mac-delimiter { colon | hyphen | none | single-hyphen} } | { network index { disable | enable} } | { region { group | none | provincial} } | retransmit-timeout index seconds | realm { add | delete} index realm-string}
Syntax Description
add |
Adds a RADIUS accounting server (IPv4 or IPv6). |
index |
RADIUS server index (1 to 17). |
IP addr |
RADIUS server IP address (IPv4 or IPv6). |
port |
RADIUS server’s UDP port number for the interface protocols. |
ascii |
Specifies the RADIUS server’s secret type: ascii . |
hex |
Specifies the RADIUS server’s secret type: hex . |
secret |
RADIUS server’s secret. |
enable |
Enables a RADIUS accounting server. |
disable |
Disables a RADIUS accounting server. |
delete |
Deletes a RADIUS accounting server. |
disable |
Disables IPSec support for an accounting server. |
enable |
Enables IPSec support for an accounting server. |
mac-delimiter |
Configures MAC delimiter for caller station ID and calling station ID. |
colon |
Sets the delimiter to colon (For example: xx:xx:xx:xx:xx:xx). |
hyphen |
Sets the delimiter to hyphen (For example: xx-xx-xx-xx-xx-xx). |
none |
Disables delimiters (For example: xxxxxxxxxx). |
single-hyphen |
Sets the delimiters to single hyphen (For example: xxxxxx-xxxxxx). |
network |
Configures a default RADIUS server for network users. |
group |
Specifies RADIUS server type group. |
none |
Specifies RADIUS server type none. |
provincial |
Specifies RADIUS server type provincial. |
retransmit-timeout |
Changes the default retransmit timeout for the server. |
seconds |
The number of seconds between retransmissions. |
realm |
Specifies radius acct realm. |
add |
Adds radius acct realm. |
delete |
Deletes radius acct realm. |
Command Default
When adding a RADIUS server, the port number defaults to 1813 and the state is enabled .
Usage Guidelines
IPSec is not supported for IPv6.
Command History
Release | Modification |
---|---|
7.6 | This command was introduced in a release earlier than Release 7.6. |
8.0 |
This command supports both IPv4 and IPv6 address formats. |
Examples
The following example shows how to configure a priority 1 RADIUS accounting server at 10.10.10.10 using port 1813 with a login password of admin :
(Cisco Controller) > config radius acct add 1 10.10.10.10 1813 ascii admin
The following example shows how to configure a priority 1 RADIUS accounting server at 2001:9:6:40::623 using port 1813 with a login password of admin :
(Cisco Controller) > config radius acct add 1 2001:9:6:40::623 1813 ascii admin