Configuring Inter Release Controller Mobility in Wireless Deployments supporting AireOS and Catalyst 9800 Controllers

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: October 13, 2022

Chapter: Restrictions while configuring IRCM

Restrictions for IRCM

Restrictions for IRCM

Consider the following before configuring IRCM.

IPv6 is not supported for SDA IRCM for fabric client roaming. IPv6 is supported for IRCM for non-fabric client roaming.
IRCM is not supported in FlexConnect and FlexConnect+Bridge modes.
Link Local bridging is not supported. Ensure that you disable it also on the peer Cisco AireOS controller.
IPv6 Central Web Authentication (CWA) is not supported for IRCM with Cisco AireOS controllers and Cisco Catalyst 9800 Series Wireless Controller.
Only eight IPv6 addresses are supported per client.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)