Cisco Mobility Express Deployment Guide Release 8.4.100.0

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: October 3, 2017

Chapter: Managing Mobility Express Deployments from Cisco Prime Infrastructure

Adding Mobility Express to Prime

Managing Mobility Express Deployments from Cisco Prime Infrastructure

Cisco Prime Infrastructure 3.01 or later can be utilized to monitor multiple instances of Cisco Mobility Express deployment.

Adding Mobility Express to Prime

Adding Mobility Express to Prime

Perform the following steps to add the controllers:

Procedure

Step 1

Step 2

Navigate to Configuration / Network / Network Devices, click on Add Device.

Step 3

Enter the IP address of the Mobility Express controller.

Step 4

Enter the SNMP Parameters and click Add.

Note

You must configure the SNMP community strings on the Mobility Express controller prior to adding the device in Prime.

Step 5

After the device is added, it shows up in the All Devices list.

Step 6

To view the list of WLANs, navigate to Network Devices > Device Groups > Device Type > Wireless Controller and select the Mobility Express controller you added in Step 4.