Using the Reset Button
Using the Reset button (see Connectors and Ports), you can reset the AP to factory default or clear the AP's internal storage.
![]() Note |
Using the Reset button does not change the booting OS (CAPWAP or URWB). |
To reset the AP to the default factory-shipped configuration, perform the following steps:
Procedure
Step 1 |
Press, and continue to press the Reset button on the access point during the AP boot cycle. |
||
Step 2 |
Press until the AP status LED changes to blinking red. It indicates that the Reset signal has been caught by u-boot. |
||
Step 3 |
|