Configuring and Validating of Point-to-Point Relay Topology
The following image shows two radio interfaces on a single device (MP1) to implement a point-to-point relay topology:
![](/c/dam/en/us/td/i/300001-400000/380001-390000/388001-389000/388134.jpg)
To configure point-to-point relay topology, follow these scenarios:
-
Configure Mesh End (ME), MP1 on channel 36 and MP2 on the default channel 149.
-
Continue from step 1 configuration.
-
Enable the second slot interface on Mesh Point (MP2) again and wait 30 seconds to implement the point-to-point relay topology for two radio interfaces on a single device.