Configure Indoor Deployment

Configure Indoor Deployment

From IOS XE Release 17.12, IW9167IH supports indoor deployment for -E and -ROW(GB) domains.

Table 1. Domains and Countries Supporting Indoor Deployment

PID

Description

IW9167IH-E

EU domain

IW9167IH-ROW (GB)

ROW domain configured with the GB country code

The -E and -ROW(GB) domains support U-NII-2C (excludes channel 144). Indoor deployment involves U-NII-1 and U-NII-2A to channel list.

When indoor deployment is disabled, 5G radio supports channels 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140.

When indoor deployment is enabled, 5G radio supports channels 36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140.

Enable Indoor Mode

To enable indoor mode, use the following procedure on the wireless controller.

Procedure

Run the command to enable the indoor mode.

Device#ap name < ap-name> indoor

The ap name <ap-name> indoor command triggers an AP rebooting. After the AP reboots and registers with the wireless controller, you need to assign the corresponding country code to the AP.

Disable Indoor Mode

To disable indoor mode, use the following procedure on the wireless controller.

Procedure

Run the command to disable the indoor mode.

Device#ap name < ap-name> no indoor

Note

 

Channel list extends from U-NII-2c to U-NII-1, U-NII-2a, U-NII-2c (channel 144 is excluded).

Verify Indoor Deployment

To verify the indoor deployment, use the show ap name <ap_name> config general command.

The following is a sample output when the indoor deployment is enabled:

Device#show ap name <ap_name> config general | inc Indoor
    AP Indoor Mode                                  : Enabled

The following is a sample output when the indoor deployment is disabled:

Device#show ap name <ap_name> config general | inc Indoor
    AP Indoor Mode                                  : Disabled