Configuring Sx-u Interface for CUPS

The following section provides the configuration commands to enable or disable the feature.

Associating Sx-u Interface to SAEGW Service

Use the following commands to associate an existing GTP-U service to an existing Control Plane function under SAEGW Service Configuration Mode. 

configure 
   context context_name 
      saegw-service service_name  
         [ no ] associate gtpu-service gtpu_service_name up-tunnel 
         end

NOTES:

  • no : Removes the selected association from this service.

  • up-tunnel : Configures the interface type as up-tunnel (tunnel towards User Plane function).

  • By default, this command is disabled.

Associating Sx-u Interface to User Plane Service

Use the following commands to associate an existing GTP-U service to an existing User Plane function under User Plane Configuration Mode. 

configure 
   context context_name 
      user-plane-service service_name  
         [ no ] associate gtpu-service gtpu_service_name cp-tunnel 
         end

NOTES:

  • no : Removes the selected association from this service.

  • cp-tunnel : Configures the interface type as cp-tunnel (tunnel towards Control Plane function).

  • By default, this command is disabled.