Table Of Contents
M Commands
mkdir
move
M Commands
The commands in this chapter apply to the Cisco MDS 9000 Family of multilayer directors and fabric switches. All commands are shown here in alphabetical order regardless of command mode. See the "Command Modes" section to determine the appropriate mode for each command. For more information, refer to the Cisco MDS 9000 Family Configuration Guide.
•
mkdir
•
move
mkdir
To create a directory in the Flash file system, use the mkdir command in EXEC mode.
mkdir directory
Syntax Description
directory
|
Name of the directory to create.
|
Defaults
This command has no default settings.
Command Modes
EXEC
Command History
This command was introduced in Cisco MDS SAN-OS Release 1.0(2).
Usage Guidelines
This command is only valid on Class C Flash file systems.
You can specify whether to create the directory on bootflash: or on slot0 or on volatile:
If you do not specify the directory name in the command line, the switch prompts you for it.
Examples
The following example creates a directory called test in the slot0 directory.
The following example creates a directory called test at the current directory level.
If the current directory is slot0:mydir, this command creates a directory called slot0:mydir/test.
Related Commands
Command
|
Description
|
dir
|
Displays a list of files on a file system.
|
rmdir
|
Removes an existing directory in the Flash file system.
|
move
To remove a file from the source directory and place it in the destination directory, use the move command in EXEC mode.
move {bootflash: | slot0: | volatile:} directory {bootflash: | slot0: | volatile:} directory
Syntax Description
bootflash:
|
Source or destination location for internal bootflash memory.
|
slot0:
|
Source or destination location for the CompactFlash memory or PCMCIA card.
|
volatile:
|
Source or destination location for volatile memory.
|
directory
|
Name of the directory to move or to create.
|
Defaults
None.
Command Modes
EXEC mode.
Command History
This command was introduced in Cisco MDS SAN-OS Release 1.0(2).
Usage Guidelines
If you do not specify the directory name in the command line, the switch prompts you for it.
Examples
The following example moves the file called samplefile from the slot0 directory to the mystorage directory.
switch# move slot0:samplefile slot0:mystorage/samplefile
The following example moves a file from the current directory level.
switch# move samplefile mystorage/samplefile
If the current directory is slot0:mydir, this command moves slot0:mydir/samplefile to
slot0:mydir/mystorage/samplefile.
Related Commands
Command
|
Description
|
dir
|
Displays a list of files on a file system.
|
mkdir
|
Creates a directory in the Flash file system.
|
rmdir
|
Removes an existing directory in the Flash file system.
|