The commands in this chapter apply to the Cisco MDS 9000 Family of multilayer directors and fabric switches. All commands are shown here in alphabetical order regardless of command mode. See the "Command Modes" section to determine the appropriate mode for each command. For more information, refer to the Cisco MDS 9000 Family Configuration Guide.
To enable the QoS priority assignment for control traffic feature on the Cisco MDS 9000 family of switches, use the qos control command in configuration mode. To disable the QoS priority assignment for control traffic feature. use the no form of the command.
qos control priority value
no qos control value
Syntax Description
qos control
Controls QoS traffic from one fabric controller to another.
priority
Sets the priority level.
value
Specifies priority value ranging from 0 to 7.
Defaults
Enabled and priority 7 are the defaults.
Command Modes
Configuration mode.
Command History
This command was introduced in Cisco MDS SAN-OS Release 1.0(2).
Usage Guidelines
None.
Examples
The following example disables the QoS priority assignment feature.