The commands in this chapter apply to the Cisco MDS 9000 Family of multilayer directors and fabric switches. All commands are shown here in alphabetical order regardless of command mode. See "About the CLI Command Modes" section on page 1-3 to determine the appropriate mode for each command. For more information, refer to the Cisco MDS 9000 Family CLI Configuration Guide.
job name
To assign a job to a command schedule, use the job name command. To remove the job, use the no form of the command.
job name job-name
no job name job-name
Syntax Description
job-name
Specifies the job name for the command schedule to run.
Defaults
None.
Command Modes
Scheduler schedule configuration submode.
Command History
Release
Modification
2.0(x)
This command was introduced.
Usage Guidelines
To use this command, the command scheduler must be enabled using the scheduler enable command.
You can configure multiple jobs in a command schedule.
Examples
The following example shows how to specified the job for a command schedule.
switch# config terminal
switch(config)# scheduler schedule name MySchedule