-
Cisco CallManager Serviceability System Guide, Release 4.1(2)
-
Preface
-
Introduction
-
Performance Objects and Counters
-
Cisco CallManager Services
-
Tools Overview
-
Service Activation
-
Control Center
-
Alarms
-
Trace
-
Real-Time Monitoring Tool
-
Quality Report Tool
-
Serviceability Reports Archive
-
Microsoft Performance
-
Bulk Trace Analysis
-
CDR Analysis and Reporting
-
Remote Serviceability Overview
-
Cisco Secure Telnet
-
Show Command Line Interface
-
Simple Network Management Protocol
-
CiscoWorks2000
-
Path Analysis
-
System Log Management
-
Cisco Discovery Protocol Support
-
Cisco CallManager Performance Counters, RTMT, and CISCO-CCM-MIB
-
Trace Examples
-
Performance Objects and Counters
-
Index
-
Feedback
Table Of Contents
Where to Find More Information
Show Command Line Interface
This chapter provides an overview of the Cisco Show command (see Show Command Syntax).
A command line tool, show, displays the contents of the Cisco CallManager configuration database, configuration file, memory statistics, and/or the Windows diagnostic information.
Show Command Syntax
You must install the Cisco CallManager to use the show tool. Run the show command from a DOS shell. You can display the output data on the console or save it into a text file.
Note
Because the show command uses a temporary file in the \Temp directory for the output, check to see that you have enough disk space available to receive it. The amount that you will need varies depending on a number of factors; for example, the number of users and devices being used and the size of the database being used by the system.
Alternatively, you can run show.exe from a Telnet session if Telnet server software is enabled.
The Program Files\Cisco\Bin directory contains the file show.exe.
The following syntax applies for the show command:
show [-f <filename>] [-c <column width>] [-w <console width>] [-v] [command]
Where to Find More Information
Related Topic
•
Additional Cisco Documentation
•
