Security Appliance Configuration Utility

Use the following checklists to quickly configure advanced options of the security appliance

	Firewall and NAT Rules
	1. Configure Custom Services (Optional)
	2. Configure Schedules (Optional)
	3. Configure Firewall and NAT Rules

	Secondary WAN Port
	1. Set Optional Port to WAN
	2. Configure WAN settings for Optional Port
	3. Configure WAN Mode
	4. Configure Protocol Bindings (Optional - if WAN Mode set to Load Balancing)

	DMZ Port
	1. Set Optional Port to DMZ mode
	2. Configure DMZ settings
	3. Configure DMZ DHCP Reserved IPs (Optional)
	4. Configure Firewall and NAT Rules

	ProtectLink Web & Email Security
	1. Enable ProtectLink Gateway and/or Endpoint

	Intrusion Prevention System (IPS)
	1. Install License
	2. Update Signatures
	3. Configure and Enable IPS policies

	Site-to-Site VPN
	1. VPN Wizard (Select Site-to-Site)
	2. Review IKE Policy created by Wizard (Optional)
	3. Review VPN Policy created by Wizard (Optional)

	IPsec VPN Remote Access
	1. VPN Wizard (Select Remote Access)
	2. Review IKE Policy (Optional)
	3. Review VPN Policy (Optional)
	4. Add Users
	5. Enable Remote Management for Cisco QuickVPN clients

	SSL VPN Remote Access
	1. Enable Remote Management
	2. SSL VPN Portal Layouts (review default settings or create new portal)
	3. Configure Domains (Optional)
	4. Configure Groups (Optional)
	5. Configure Users
	6. Configure SSL VPN Policies (Optional)
	7. Review SSL VPN Client settings and edit as needed (Optional)
	8. Configure Client Routes (only if split tunnel enabled on Client settings page)
	9. Configure Resources (Optional)