Administrators

This link leads to the Admin Access window where you can add users to and remove them from the system and assign user capabilities.

Username

Displays the username of the active user.

Read-Only

Specifies whether the user has read-only capabilities.

Read-Write

Specifies whether the user has read/write capabilities.

Service Set Identifiers (SSIDs)

This link leads to the SSID Manager window where you can specify authentication methods and define VLANs.

SSID

Specifies the unique identifier the client devices use to associate with the access point.

VLAN

Specifies the VLANs that are currently assigned.

Radio

Specifies which radio is being used.

BSSID/Guest Mode

Specifies the BSSID/Guest mode attached to this SSID.

Open/Shared/Network EAP

Specifies the method of authentication being used. Open enables any device to authenticate and then attempt to communicate with the access point. Shared sends an unencrypted challenge string to any device attempting to communicate with the access point. Network EAP uses EAP to interact with an EAP-compatible server on your network to provide authentication for wireless client devices.

Encryption Settings

Click Radio0-802.11b Encryption Settings, Radio1-802.11a Encryption Settings, or Radio0-802.11g Encryption Settings to go to the WEP Key Manager/Encryption Manager window.

Encryption Mode

Indicates whether clients should use data encryption when communicating with the device. The options are none, WEP encryption, or cipher. The remaining columns that do not apply based on your encryption mode choice are unavailable.

MIC

Specifies whether MIC is enabled. WEP encryption must be set to Mandatory for MIC to be enabled.

PPK

Specifies whether per packet keying is enabled. With WEP key rotation enabled, the access point provides a dynamic broadcast WEP key and changes it at the interval you specify.

TKIP

Specifies whether Cipher-TKIP is enabled.

WEP40bit

Specifies whether Cipher-WEP40BIT is enabled.

WEP128bit

Specifies whether Cipher-WEP128BIT is enabled.

CKIP

Specifies whether Cipher-CKIP is enabled.

CMIC

Specifies whether Cipher-CMIC is enabled.

Key Rotation

Displays at which frequency the broadcast key is changed.

Server-Based Security

This link leads to the Server Manager page where you identify the remote servers to be used for authentication.

Server Name/IP Address

Specifies the name or IP address of the server.

Type

Specifies the type of server.

EAP/MAC/Proxy Mobile IP/Admin/Accounting

Specifies what the server will be used for.