The following example illustrates Ten
Gigabit EtherChannel information for the port-channel interface of 2.
This configuration is comprised of
three Ten GEC port channels as follows:
- Member 0 is the Ten GEC
interface bundle master.
- Member 2 is the final
slave interface in this Ten GEC group.
- These three port-channel
interfaces (members) comprise one Ten GEC group that is set up with a Ten GEC
peer on the network.
Router# show interface port-channel 2
Port-channel2 is up, line protocol is up
Hardware is GEChannel, address is 8888.8888.8888 (bia 0000.0000.0000)
Internet address is 101.101.101.1/16
MTU 1500 bytes, BW 3000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
No. of members in this channel: 3
No. of configured members in this channel: 3
No. of passive members in this channel: 0
No. of active members in this channel: 3
Member 0 : TenGigabitEthernet4/1/0 , Full-duplex, 1000Mb/s
Member 1 : TenGigabitEthernet4/1/1 , Full-duplex, 1000Mb/s
Member 2 : TenGigabitEthernet4/1/2 , Full-duplex, 1000Mb/s
No. of Non-active members in this channel: 0
Last input 00:00:02, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/225/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/120 (size/max)
30 second input rate 17292000 bits/sec, 9948 packets/sec
30 second output rate 17315000 bits/sec, 9935 packets/sec
866398790 packets input, 3324942446 bytes, 0 no buffer
Received 2 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
866394055 packets output, 3323914794 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out