New and Changed Information

New and Changed Information

The following table provides an overview of the significant changes to the organization and features in this guide up to the specified release. The table does not provide an exhaustive list of all changes made to the guide or of the new features up to that release.

Table 1. New Features and Changed Behavior in Cisco APIC Release 6.0(4)

Feature or Change

Description

Where Documented

Control plane (CP) maximum transmission unit (MTU) policy

 Enables the configuration of the Cisco APIC fabric and in-band management MTU to the control plane MTU when the control plane MTU is configured for less than 1,500 bytes. Configuring the Cisco APIC MTU to the Control Plane MTU Using the GUI
Table 2. New Features and Changed Behavior in Cisco APIC Release 6.0(3)

Feature or Change

Description

Where Documented

Transmission control protocol (TCP) maximum segment size (MSS) adjustment

 You can adjust the transmission control protocol (TCP) maximum segment size (MSS) to avoid packet fragmentation or drops. TCP MSS Adjustment
Table 3. New Features and Changed Behavior in Cisco APIC Release 6.0(1)

Feature or Change

Description

Where Documented

Support for PTP G.8275.1 on remote leaf switch peer links and on vPCs

You can use the PTP Telecom profile (G.8275.1) on virtual port channels (vPCs) and on remote leaf switch peer links.

Supported PTP Interface Connectivity

Support for SyncE on vPCs and on remote leaf switch peer links

You can use SyncE on vPCs and on remote leaf switch peer links.

Guidelines and Limitations for SyncE