Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 10.5(x)

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: July 27, 2024

New and Changed Information

This table summarizes the new and changed features for the Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 10.5(x) and where they are documented.

Table 1. New and Changed Features
Feature	Description	Changed in Release	Where Documented
PID-specific SMUs	Added support for installation of PID-specific SMUs only on the PIDs they are meant for	10.5(1)F	Guidelines and Limitations for SMUs
SMU Retry/Reload Switch if SMU install Fails	Added support to reload the switch automatically when a valid and compatible SMU that needs to be activated, fails to activate	10.5(1)F	Guidelines and Limitations for SMUs
PTP Time Distribution Hold	Added support for holding time distribution until a BC node locks to primary time source and settles down to the target correction value.	10.5(1)F	PTP Time Distribution Hold Guidelines and Limitations for PTP Configuring PTP Globally

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)