Changing the Management IP Address
Before you begin
You can change the management IP address on the Firepower 4100/9300 chassis from the FXOS CLI.
Note |
After changing the management IP address, you will need to reestablish any connections to Firepower Chassis Manager or the FXOS CLI using the new address. |
Procedure
Step 1 |
Connect to the FXOS CLI (see Accessing the FXOS CLI). |
Step 2 |
To configure an IPv4 management IP address: |
Step 3 |
To configure an IPv6 management IP address: |
Example
The following example configures an IPv4 management interface and gateway:
Firepower-chassis# scope fabric-interconnect a
Firepower-chassis /fabric-interconnect # show
Fabric Interconnect:
ID OOB IP Addr OOB Gateway OOB Netmask OOB IPv6 Address OOB IPv6 Gateway Prefix Operability
---- --------------- --------------- --------------- ---------------- ---------------- ------ -----------
A 192.0.2.112 192.0.2.1 255.255.255.0 :: :: 64 Operable
Firepower-chassis /fabric-interconnect # set out-of-band ip 192.0.2.111 netmask 255.255.255.0 gw 192.0.2.1
Warning: When committed, this change may disconnect the current CLI session
Firepower-chassis /fabric-interconnect* #commit-buffer
Firepower-chassis /fabric-interconnect #
The following example configures an IPv6 management interface and gateway:
Firepower-chassis# scope fabric-interconnect a
Firepower-chassis /fabric-interconnect # scope ipv6-config
Firepower-chassis /fabric-interconnect/ipv6-config # show ipv6-if
Management IPv6 Interface:
IPv6 Address Prefix IPv6 Gateway
----------------------------------- ---------- ------------
2001::8998 64 2001::1
Firepower-chassis /fabric-interconnect/ipv6-config # set out-of-band ipv6 2001::8999 ipv6-prefix 64 ipv6-gw 2001::1
Firepower-chassis /fabric-interconnect/ipv6-config* # commit-buffer
Firepower-chassis /fabric-interconnect/ipv6-config #