Switch Mounting
This chapter describes how to mount the switch.
Mounting the Switch
Caution |
To prevent the switch from overheating, ensure these minimum clearances:– Top and bottom: 2.0 in. (50.8 mm)– Exposed side (not connected to the module): 2.0 in. (50.8 mm) – Front: 2.0 in. (50.8 mm) |
Installing the Switch on the Wall
To attach the switch to a wall or a panel, follow these steps.
Warning |
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system. Statement 378 |
Procedure
Step 1 |
Position the switch mounting bracket against the wall or a panel in the desired location, with the arrow pointing up. See the following figure. Attach the bracket to the wall with the 4 enclosed Philips screws.
|
||
Step 2 |
Loosly attach the 4 mounting screws to the switch and slide it into the bracket and down. See the following figure. |
||
Step 3 |
To remove the switch, loosen the 4 mounting screws and slide the switch up and forward, out of the mounting bracket. Then the bracket itself can be unscrewed from the wall, if necessary. |
What to do next
After the switch is mounted on the wall or panel, connect the power and alarm wires, as described in the “Connecting Alarm Circuits” section on page -12 .