The Cisco UCS Fabric Interconnect accessory kit includes the following items:

• 2 slider rails

• 2 rear rack-mount guides

• 2 front rack-mount brackets

• 12 M4 x 0.7 x 8-mm Phillips countersunk screws

• 10 10-32 rack nuts

• 10 10-32 x 3/4-inch Phillips pan-head screws

• 1 RS-232 console cable with an RJ-45 adapter and a DB9 adapter

• 1 ground-lug kit

• 1 ESD wrist strap

• 1 power cord clip (a wire clip that is used to retain the power cord)

• 1 pointer document (specifies where to find the online product documentation)

Note	Additional parts can be ordered from your customer service representative.

Console Cable

The console cable has an RJ-45 connector on one end and a DB9 connector on the other; this cable is used to connect into the RS-232 console connection on a laptop.

The console port is an asynchronous RS-232 serial port with an RJ-45 connector.

The table below lists the pinouts for the console port on the Cisco UCS 6454 Fabric Interconnect.

Depending on the laptop you use for the initial configuration, you may also want a USB 2.0 to Serial (9-pin) DB-9 RS-232 Adapter Cable as well as a terminal program like Hyperterminal or PuTTY (set to connect at 9600 baud, 8 data bits, 1 stop bit, no parity).

Each power supply has a separate power cord. Standard power cords or jumper power cords are available for connection to a power distribution unit having IEC 60320 C13 outlet receptacles. The jumper power cords, for use in cabinets, are available as an optional alternative to the standard power cords.

The standard power cords have an IEC C13 connector on the end that plugs into the power supplies. The optional jumper power cords have an IEC C13 connector on the end that plugs into the power supplies, and an IEC C14 connector on the end that plugs into an IEC C13 outlet receptacle.

Note	Only the regular power cords or jumper power cords provided with the chassis are supported.