Prerequisites for Cisco Unified Communications Manager Express
Note |
This section applies to a new installation of Cisco Unity Express Virtual. |
If you are using Cisco Unified Communications Manager Express (Cisco Unified CME) with your Cisco Unity Express Virtual system, Cisco Unified CME must be installed before you configure Cisco Unity Express Virtual. If you did not perform the Cisco Unified CME installation, contact the designated installer to ensure that the following procedures are completed:
Procedure
Step 1 |
Verify that the version of Cisco Unified CME is compatible with Cisco Unity Express Virtual. See the Cisco Unity Express Compatibility Matrix. |
||
Step 2 |
Install all Cisco Unified CME and Cisco Unity Express Virtual hardware and verify functionality. |
||
Step 3 |
Install and verify Cisco Unified CME software functionality. Depending on the version of Cisco Unified CME, you can perform some configuration using the Cisco Unified CME graphical user interface. If the version of Cisco Unified CME does not support the GUI, see Cisco Unified Communications Manager Express Administrator Guide. If your version of Cisco Unified CME supports the GUI, proceed with the following steps:
|
||
Step 4 |
The FTP server that communicates with Cisco Unity Express Virtual must support passive FTP requests. To configure this functionality on the FTP server, see your FTP server documentation. |
||
Step 5 |
(Optional) If no subscribers were created in the Cisco Unified CME interface, create a list of all subscribers, groups, and their extensions to simplify the task of configuring many subscribers and extensions. |