この製品のマニュアルセットは、偏向のない言語を使用するように配慮されています。このマニュアルセットでの偏向のない言語とは、年齢、障害、性別、人種的アイデンティティ、民族的アイデンティティ、性的指向、社会経済的地位、およびインターセクショナリティに基づく差別を意味しない言語として定義されています。製品ソフトウェアのユーザーインターフェイスにハードコードされている言語、RFP のドキュメントに基づいて使用されている言語、または参照されているサードパーティ製品で使用されている言語によりドキュメントに例外が存在する場合があります。シスコのインクルーシブランゲージに対する取り組みの詳細は、こちらをご覧ください。
このドキュメントは、米国シスコ発行ドキュメントの参考和訳です。リンク情報につきましては、日本語版掲載時点で、英語版にアップデートがあり、リンク先のページが移動/変更されている場合がありますことをご了承ください。あくまでも参考和訳となりますので、正式な内容については米国サイトのドキュメントを参照ください。
この付録では、Cisco Aironet 1552 屋外メッシュ アクセス ポイントに関する適合宣言と規制情報について説明します。
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
このデバイスは、Part 15 の規定に適合しており、動作は次の 2 つの条件を前提としています。
1. このデバイスによって、有害な干渉が発生することはない。
2. このデバイスは、予想外の動作を引き起こす可能性のある干渉も含め、すべての干渉を受け入れなければならない。
この機器は、FCC 規定の Part 15 に基づくクラス B デジタル デバイスの制限に準拠していることがテストによって確認済みです。制限は、住宅地で機器を使用した場合に有害な干渉が起きないようにするための、一定の保護を目的としたものです。この機器は無線周波エネルギーを生成、使用、および放射するため、指示に従わずに取り付けたり使用したりした場合は、有害な干渉を発生させるおそれがあります。ただし、説明書に従った場合にも、干渉が起きないことを保証するものではありません。この機器によってラジオやテレビの受信に干渉が発生する場合は(機器の電源をオン/オフすることで確認できます)、次のいずれかの方法で干渉をなくすようにしてください。
この Class B のデジタル機器は、Canadian Interference-Causing Equipment Regulations のすべての要件を満たしています。
Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material broilleur du Canada.
このデバイスはカナダ産業省の Class B の制限に適合しています。次の 2 つの条件に従って動作するものとします。
1. 本製品が、有害な干渉を発生することはありません。および、
2. 本製品は、望ましくない動作を引き起こす可能性のある干渉を含む、すべての干渉を受け入れなければなりません。
Cisco Aironet アクセス ポイントは、RSS-210 の要件を満たしています。部分的または完全に屋外で動作するシステムでこのデバイスを使用する場合、ユーザはカナダの規定に従ってそのシステムの免許を取得しなければならないことがあります。詳細については、最寄のカナダ産業省事務局へお問い合わせください。
1552H デバイスは、2.4 GHz の場合は 4 dBi、5 GHz の場合は 7 dBi の最大ゲインを得るアンテナを使用するよう設計されています。最大ゲインを超えるアンテナをこのデバイスで使用することは固く禁じられています。アンテナに要求されるインピーダンスは 50 Ω です。
1552SA/1552SD デバイスは、802.11 の場合は 4 dBi、2.4 GHz 帯域のセンサー(802.15.4)無線の場合は 14 dBi、5 GHz 帯域では 7 dBi の最大ゲインを得るアンテナを使用するよう設計されています。最大ゲインを超えるアンテナをこのデバイスで使用することは固く禁じられています。アンテナに要求されるインピーダンスは 50 Ω です。
他のユーザへの干渉を減らすために、Equivalent Isotropically Radiated Power(EIRP; 等価等方放射電力)が正常な通信に必要な値を超えないようにアンテナの種類とゲインを選択してください。
このアクセス ポイントは、無線周波数電磁場における人体の被曝に関する FCC ガイドラインに従って評価され、無線周波デバイスによる RF 被曝の影響に関する CFR 47 第 1.1307 項の要件を満たすことが判明しています。アンテナは、設置担当者または周囲の人から 20 cm(7.9 インチ)以上離して設置する必要があります。
この宣言は、シスコシステムズが提供およびサポートしているソフトウェア、ファームウェア、およびハードウェアを組み合わせた構成にのみ適用されます。シスコシステムズが提供およびサポートしているソフトウェアやファームウェアを使用していない場合、本装置が法的要件を満せなくなる場合があります。s
EMC:EN 301.489-1 v1.8.1、EN 301.489-17 v2.1.1
安全性:EN60950-1: 2005、EN 50385: 2002
無線:EN 300 328 v 1.7.1、EN 301.893 v 1.5.1
指令 1999/5/EC の第 10.4 項および別紙 III の適合性評価手順を順守しています。
このデバイスは、Medical 指令(93/42/EEC)の EMC 要件にも準拠しています。
注 本装置は、EU および EFTA 各国で使用することを目的としています。屋外での使用は、一定の周波数に制限されたり、また使用にあたっては資格が必要となる場合があります。詳細は、Cisco Corporate Compliance にお問い合わせください。
ここでは、ブラジルにおける Cisco Aironet アクセス ポイントの使用に関する情報を示します。
図 1 は、前述したアクセス ポイント モデルのブラジル規制情報を示しています。
米国、カナダ、欧州連合、およびオーストラリアの RF 被曝に関する適合宣言を次に示します。
ANSI C 95.1(American National Standards Institute; 米国規格協会)の制限値を基準として、人体に対する RF 被曝レベルが評価されています。この評価は ANSI C 95.1 および FCC OET Bulletin 65C rev 01.01 に基づいています。適合性を維持するために、アンテナは人体から 20 cm(7.9 インチ)以上の距離をあけて設置する必要があります。
ANSI C 95.1(American National Standards Institute; 米国規格協会)の制限値を基準として、人体に対する RF 被曝レベルが評価されています。この評価は RSS-102 Rev 2 に基づいています。適合性を維持するために、アンテナは人体から 20 cm(7.9 インチ)以上の距離をあけて設置する必要があります。
国際非電離放射線防護委員会(ICNIRP)の制限値を基準として、人体に対する RF 被曝レベルが評価されています。この評価は、300 MHz ~ 40 GHz の EN 50385 Product Standard to Demonstrate Compliance of Radio Base Stations and Fixed Terminals for Wireless Telecommunications Systems with basic restrictions or reference levels related to Human Exposure to Radio Frequency Electromagnetic Fields(無線周波数の電磁場が人体に及ぼす影響に関連する基本規定または基準レベルに対する、無線通信システム用の無線のベース ステーションおよび固定端末ステーションの準拠を示す製品規格)に基づいています。アンテナは人体から 20 cm(7.9 インチ)以上の距離をあけて設置する必要があ り ます。ダ イバーシテ ィ用のデュ アル アンテナは、同じ場所への設置と は見な されません。
オーストラリア放射線防護基準および国際非電離放射線防護委員会(ICNIRP)の制限値を基準として、人体に対する RF 被曝レベルが評価されています。アンテナは人体から 20 cm(7.9 インチ)以上の距離をあけて設置する必要があります。
この項では、日本で Cisco Aironet アクセス ポイントを使用する際に、干渉を回避するためのガイドラインを示します。このガイドラインは、日本語と英語で提供されています。
This equipment operates in the same frequency bandwidth as industrial, scientific, and medical devices such as microwave ovens and mobile object identification (RF-ID) systems (licensed premises radio stations and unlicensed specified low-power radio stations) used in factory production lines.
1. Before using this equipment, make sure that no premises radio stations or specified low-power radio stations of RF-ID are used in the vicinity.
2. If this equipment causes RF interference to a premises radio station of RF-ID, promptly change the frequency or stop using the device; contact the number below and ask for recommendations on avoiding radio interference, such as setting partitions.
3. If this equipment causes RF interference to a specified low-power radio station of RF-ID, contact the number below.
Specific notes on Japan explosion-proof certification are as follows. AIR-CAP1552H-Q-K9 (POE input configuration only).
1. Use a heat-resistant cable of 65 degree or higher for various cables connected to the equipment.
2. This model uses the following cable gland / blind plug for the input / output port of this unit.
(TIIS Certified parts as of Jan/2017)
For Cable ground of Fiber Port and PoE port
Cable Grand: Ceftec Electric Co., Ltd. SFGU 10-M-ESBlind plug: Ceftec Electric Co., Ltd. PXN10-M20
3. Do not attach / detach the antenna in an explosive atmosphere or in a dangerous place.
![]() |
|
![]() |
![]() |
ここでは、台湾における Cisco Aironet アクセス ポイントの使用に関する行政規定を示します。この規定は、中国語と英語で提供されています。
Administrative Rules for Low-power Radio-Frequency Devices
For those low-power radio-frequency devices that have already received a type-approval, companies, business units or users should not change its frequencies, increase its power or change its original features and functions.
The operation of the low-power radio-frequency devices is subject to the conditions that no harmful interference is caused to aviation safety and authorized radio station; and if interference is caused, the user must stop operating the device immediately and can't re-operate it until the harmful interference is clear.
The authorized radio station means a radio-communication service operating in accordance with the Communication Act.
The operation of the low-power radio-frequency devices is subject to the interference caused by the operation of an authorized radio station, by another intentional or unintentional radiator, by industrial, scientific and medical (ISM) equipment, or by an incidental radiator.
Low-power Radio-frequency Devices Technical Specifications
Unlicensed National Information Infrastructure
The U-NII devices shall accept any interference from legal communications and shall not interfere the legal communications.If interference is caused, the user must stop operating the device immediately and can't re-operate it until the harmful interference is clear.
Manufacturers of U-NII devices are responsible for ensuring frequency stability such that an emission is maintained within the band of operation under all conditions of normal operation as specified in the user manual.
When installing the product, please use the provided or designated connection cables/power cables/AC adapters. Using any other cables/adapters could cause a malfunction or a fire. Electrical Appliance and Material Safety Law prohibits the use of UL-certified cables (that have the “UL” shown on the code) for any other electrical devices than products designated by CISCO. The use of cables that are certified by Electrical Appliance and Material Safety Law (that have “PSE” shown on the code) is not limited to CISCO-designated products.