Sample Output from the show ipv6 mobile binding Command
Router # show ipv6 mobile binding
Mobile IPv6 Binding Cache Entries:
2001:DB8:2000::1111/64
via care-of address 2001:DB8::A8BB:CCFF:FE01:F611
home-agent 2001:DB8:2000::2001
Prefix 2001:DB8:8000::/64
Prefix 2001:DB8:2000::1111/128
Prefix 2001:DB8:1000::1111/128 installed
state ACTIVE, sequence 23, flags AHRlK
lifetime: remaining 44 (secs), granted 60 (secs), requested 60 (secs)
interface Ethernet0/2
tunnel interface Tunnel0
0 tunneled, 0 reversed tunneled
Selection matched 1 bindings
Sample Output from the show ipv6 mobile globals Command
In the following example, the show ipv6 mobile globals command displays the binding parameters:
Router# show ipv6 mobile globals
Mobile IPv6 Global Settings:
1 Home Agent service on following interfaces:
Ethernet1/2
Bindings:
Maximum number is unlimited.
1 bindings are in use
1 bindings peak
Binding lifetime permitted is 262140 seconds
Recommended refresh time is 300 seconds
Sample Output from the show ipv6 mobile home-agent Command
In the following example, the fact that no neighboring mobile home agents were found is displayed:
Router# show ipv6 mobile home-agent
Home Agent information for Ethernet1/3
Configured:
FE80::20B:BFFF:FE33:501F
preference 0 lifetime 1800
global address 2001:DB8:1::2/64
Discovered Home Agents:
FE80::4, last update 0 min
preference 0 lifetime 1800
global address 2001:DB8:1::4/64
Sample Output from the show ipv6 mobile host groups Command
In the following example, information about a host group named localhost is displayed:
Router# show ipv6 mobile host groups
Mobile IPv6 Host Configuration
Mobile Host List:
Host Group Name: localhost
NAI: sai@cisco.com
Address: CAB:C0:CA5A:CA5A::CA5A
Security Association Entry:
SPI: (Hex: 501) (Decimal Int: 1281)
Key Format: Hex Key: baba
Algorithm: HMAC_SHA1
Replay Protection: On Replay Window: 6 secs
Sample Output from the show ipv6 mobile router Command
The following example provides information about the IPv6 mobile router status when the router configured with IPv6 NEMO:
Router# show ipv6 mobile router
Mobile Reverse Tunnel established
---------------------------------
using Nemo Basic mode
Home Agent: 2001:DB8:2000::2001
CareOf Address: 2001:DB8::A8BB:CCFF:FE01:F611
Attachment Router: FE80::A8BB:CCFF:FE01:F511
Attachment Interface: Ethernet1/1
Home Network: 2001:DB8:2000:0:FDFF:FFFF:FFFF:FFFE/64
Home Address: 2001:DB8:2000::1111/64
Sample Output from the show ipv6 mobile traffic Command
In the following example, information about Mobile IPv6 traffic is displayed:
Router# show ipv6 mobile traffic
MIPv6 statistics:
Rcvd: 6477 total
0 truncated, 0 format errors
0 checksum errors
Binding Updates received:6477
0 no HA option, 0 BU's length
0 options' length, 0 invalid CoA
Sent: 6477 generated
Binding Acknowledgements sent:6477
6477 accepted (0 prefix discovery required)
0 reason unspecified, 0 admin prohibited
0 insufficient resources, 0 home reg not supported
0 not home subnet, 0 not home agent for node
0 DAD failed, 0 sequence number
Binding Errors sent:0
0 no binding, 0 unknown MH
Home Agent Traffic:
6477 registrations, 0 deregistrations
00:00:23 since last accepted HA registration
unknown time since last failed HA registration
unknown last failed registration code
Traffic forwarded:
0 tunneled, 0 reversed tunneled
Dynamic Home Agent Address Discovery:
1 requests received, 1 replies sent
Mobile Prefix Discovery:
0 solicitations received, 0 advertisements sent
Sample Output from the show ipv6 mobile tunnels Command
The following example displays information about the Mobile IPv6 tunnels on the home agent:
Router# show ipv6 mobile tunnels
Tunnel1:
Source: 2001:0DB1:1:1
Destination: 2001:0DB1:2:1
Encapsulation Mode: IPv6/IPv6
Egress Interface: Ethernet 1/0
Switching Mode: Process
Keep-Alive: Not Supported
Path MTU Discovery: Enabled
Input: 20 packets, 1200 bytes, 0 drops
Output: 20 packets, 1200 bytes, 0 drops
NEMO Options: Not Supported