- Preface
- Cisco ASR1000-RP3 Module Overview
- Preparing to Install the Cisco ASR1000-RP3 Module
- Installing the Cisco ASR1000-RP3 Module
- Software Licensing on Cisco ASR1000-RP3 Module
- Configuring the Cisco ASR1000-RP3 Module
- Upgrading the Cisco ASR1000-RP3 Module
- Upgrading the ROMMON
- Removing and Replacing FRUs from the Cisco ASR1000-RP3 Module
Upgrading the Cisco ASR1000-RP3 Module
Upgrading the Software
The In-Service Software Upgrades (ISSU) procedure for ASR1000-RP3 is same as that for ASR1000-RP2.
For detailed information on the software upgrade procedures, see Software Upgrade Process chapter of the Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide.
Migrating from ASR1000-RP2 to ASR1000-RP3
This section describes the basic steps required for migrating from ASR1000-RP2 to ASR1000-RP3 without reloading the entire chassis in the field.
Step 1 Upgrade the RP2 based system to Cisco IOS XE Denali 16.3.1 or later (Universal images).
Step 2 Replace the RP2 which is in Standby mode with an RP3 card.
Step 3 Switchover from an Active RP2 to Standby RP3.
Step 4 Replace the RP2 which is in standby mode with an RP3.
Note ● ASR1000-RP3 to ASR1000-RP2 downgrade is not supported.
- Even though the ASR1000-RP2 and ASR1000-RP3 can co-exist in the chassis, it is only supported to enable customers to migrate the system to RP3 without requiring a reload.
– Follow the above upgrade process during a maintenance window and replace both RP2s with RP3.
– We do not recommend that the system runs with both RP2 and RP3 cards for a long duration.
Upgrading Complex Programmable Logic Device (CPLD)
The CPLD version for Cisco ASR1000-RP3 is 16082219. For upgrading CPLD for ASR1000-RP3, please refer to the following document: http://www.cisco.com/c/en/us/td/docs/routers/asr1000/cpld/hw_fp_upgrade.html.