- Preface
- Cisco ASR1000-RP3 Module Overview
- Preparing to Install the Cisco ASR1000-RP3 Module
- Installing the Cisco ASR1000-RP3 Module
- Software Licensing on Cisco ASR1000-RP3 Module
- Configuring the Cisco ASR1000-RP3 Module
- Upgrading the Cisco ASR1000-RP3 Module
- Upgrading the ROMMON
- Removing and Replacing FRUs from the Cisco ASR1000-RP3 Module
Upgrading the ROMMON
This chapter provides information about ROMMON used in the Cisco ASR1000-RP3 module. It contains the following sections:
Available ROMMON Version on the Cisco ASR1000-RP3 Module
The Cisco ASR1000-RP3 module is shipped with the ROMMON release 16.3(2r).
Upgrading the ROMMON Version
Note The minimum ROMMON version 16.3(2r) is already installed on the Cisco ASR1000-RP3 module at the time of purchase.
To upgrade the ROMMON, see the Cisco ASR 1000 Series Routers ROMmon Upgrade Guide at: http://www.cisco.com/c/en/us/td/docs/routers/asr1000/rommon/rommon.html.
Verifying the ROMMON Version
To verify the ROMMON version installed on the Cisco ASR1000-RP3 module, use the show platform command.
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------------------------