Cisco Cyber Vision Network Sensor Installation Guide for Cisco IC3000, Release 4.1.0

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: March 18, 2022

Connect the Cisco IC3000

The Cisco IC3000 contains 4 independent ports which can be used to capture in SPAN mode or to do active scanning on the network. Depending on the port usage the corresponding switch port must have the right configuration (SPAN or access).

The Cisco IC3000's Industrial network interface to do the dPI is to be connected to switches configured in port mirroring only.

To connect the network interfaces to the Cisco IC3000:

Procedure

Step 1

Connect the Collection network interface (IC3000 to Center) to the MGMT ENET port (1).

Step 2

Connect the Industrial network interface (IC3000 to on-site switches) to ports 1, 2, 3, 4 (up to 4 switches configured in port mirroring or access depending on the port usage).

Step 3

Ports 1 and 2 are RJ45 10/100/1000 BaseT Connectors (2).
Ports 3 and 4 are SFP fiber ports (3).

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)