Document purpose
This installation guide describes how to perform a clean installation of Cisco Cyber Vision on the following devices:
-
Cisco Catalyst IR1101 Rugged Series Router
-
Cisco Catalyst IR1800 Rugged Series Router
Consequently, all instructions about the Cisco Catalyst IR1101 are also applicable to the Cisco Catalyst IR1800.
Moreover, this document describes how to upgrade sensors through different methods.
This documentation is applicable to system version 5.0.0.
Note |
To be able to use the Cisco Cyber Vision sensor management extension, an IP address reachable by the Center Collection interface must be set on the Collection VLAN. |