Procedure with the CLI

After the Initial configuration, proceed to the steps described in this section.

Configure the sensor application

without SSD


Note
In this section, "CCVSensor" is used as the appid.

Procedure

Step 1

Connect to the Cisco IR1101 through SSH or a console.

Step 2

Configure the application payload by typing the following commands:

enable
configure terminal
app-hosting appid CCVSensor
  app-vnic gateway0 virtualportgroup 1 guest-interface 0
    guest-ipaddress 169.254.0.2 netmask 255.255.255.252
  app-vnic gateway1 virtualportgroup 0 guest-interface 1
      guest-ipaddress 169.254.1.2 netmask 255.255.255.252
  app-default-gateway 169.254.0.1 guest-interface 0
  app-resource docker
    run-opts 1 "--tmpfs /tmp:rw,size=128m"
end

with SSD


Note
In this section, "CCVSensor" is used as the appid.

Procedure

Step 1

Connect to he Cisco IR1101 through SSH or a console.

Step 2

Configure the application payload by typing the following commands:

enable
configure terminal
app-hosting appid CCVSensor
  app-vnic gateway0 virtualportgroup 1 guest-interface 0
    guest-ipaddress 169.254.0.2 netmask 255.255.255.252
  app-vnic gateway1 virtualportgroup 0 guest-interface 1
      guest-ipaddress 169.254.1.2 netmask 255.255.255.252
  app-default-gateway 169.254.0.1 guest-interface 0
  app-resource docker
    run-opts 1
end

Install the sensor application

The sensor package needs to be collected from cisco.com. The file has the following name structure:

CiscoCyberVision-IOx-aarch64-<version>.tar.

  1. Copy the package to a USB key or in the flash memory.

  2. Type the following command on the Cisco IR1101's CLI: 

    app-hosting install appid CCVSensor package usbflash0:CiscoCyberVision-IOx-aarch64-4.1.0.tar


    Note
    Adjust "usbflash0:" in accordance with the sensor package's localization (USB port or flash memory).

    Note
    Replace "CiscoCyberVision-IOx-aarch64-4.1.0.tar" with the right filename.

  3. Check that the application is in DEPLOYED state:

    show app-hosting list

  4. Activate the application using the following command:

    app-hosting activate appid CCVSensor

  5. Start the application using the following command:

    app-hosting start appid CCVSensor

Copy the sensor application's provisioning package

  • Copy the provisioning package from the USB key to the application by typing the following command:

    app-hosting data appid CCVSensor copy usbflash0:sbs-sensor-config-<serialnumber>.zip sbs-sensor-config-<serialnumber>.zip

    The sensor will appear as Connected in Cisco Cyber Vision's Sensor Explorer page.