- Preface
- New and Changed Information
- Cisco IWAN Application Overview
- Configuring and Setting Up the Hub Site
- Managing Branch Sites
- Administering Application Policies
- Monitoring and Troubleshooting Sites
- Backup and Restore, Recovery, and Delete
- Upgrading the Cisco IWAN Application
- Brownfield Validation Messages
New and Changed Information
New and Changed Information
The following table summarizes release-specific new and changed features for the Cisco IWAN application that are covered in this document.
|
|
|
|
|---|---|---|
Harmonization of the Cisco IWAN application and the EasyQoS application |
Added support to integrate the Cisco IWAN application and the EasyQoS application in the Cisco APIC-EM infrastructure. Provides a unified user experience for managing the life-cycle of applications and groups of applications. |
|
Ability to migrate existing customer branch sites to IWAN deployment. |
Adding and Provisioning Brownfield Devices to the Branch Site |
|
To have a robust IWAN offering at the cost of user input, branch provisioning worflow has been modified to accept site prefix to accommodate subnets that are on a routed network behind the border router. The site prefixes are statically configured in PFR. |
Adding and Provisioning Brownfield Devices to the Branch Site |
|
The LAN Brownfield IP address pool feature provides the ability to reserve a LAN Brownfield IP address pool before provisioning the Brownfield branch site. |
Adding and Provisioning Brownfield Devices to the Branch Site |
|
Provides the ability to update the service provider count and the remote site count after initial provisioning. Error message is displayed if the required number of addresses cannot be reserved from the Generic IP address pool. |
Feedback