The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS FabricPath commands that begin with L.
To configure the log changes in the adjacency state, use the log-adjacency-changes command. To return to the default setting, use the no form of this command.
log-adjacency-changes
no log-adjacency-changes
This command has no arguments or keywords.
ON
FabricPath IS-IS configuration mode
|
|
---|---|
5.1(3)N1(1) |
This command was introduced. |
This command requires an Enhanced Layer 2 license.
This example shows how to configure the log changes in the adjacency state:
switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fabricpath domain default
switch(config-fabricpath-isis)# log-adjacency-changes
switch(config-fabricpath-isis)#
|
|
---|---|
show fabricpath isis |
Displays FabricPath IS-IS information. |
To configure a link-state packet (LSP) generation interval, use the lsp-gen-interval command. To return to the default setting, use the no form of this command.
lsp-gen-interval {lsp-max-wait | lsp-initial-wait | lsp-second-wait}
no lsp-gen-interval {lsp-max-wait | lsp-initial-wait | lsp-second-wait}
The defaults are as follows:
•lsp-max-wait: 8000
•lsp-initial-wait: 50
•lsp-second-wait: 50
FabricPath IS-IS configuration mode
|
|
---|---|
5.1(3)N1(1) |
This command was introduced. |
You can enter the lsp-gen-interval command to control the rate of LSP packets being generated, transmitted, and retransmitted.
This command requires an Enhanced Layer 2 license.
This example shows how to configure an LSP-generation interval:
switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fabricpath domain default
switch(config-fabricpath-isis)# lsp-gen-interval 9000 60 70
switch(config-fabricpath-isis)#
|
|
---|---|
show fabricpath isis |
Displays FabricPath IS-IS information. |
To configure a link-state packet (LSP) maximum transmission unit (MTU) that is generated by the Cisco NX-OS software, use the lsp-mtu command. To return to the default setting, use the no form of this command.
lsp-mtu bytes
no lsp-mtu bytes
bytes |
Maximum LSP size in bytes. The range is from 128 to 4352. |
1492 bytes
FabricPath IS-IS configuration mode
|
|
---|---|
5.1(3)N1(1) |
This command was introduced. |
This command requires an Enhanced Layer 2 license.
This example shows how to set the maximum LSP size to 1500 bytes:
switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fabricpath domain default
switch(config-fabricpath-isis)# lsp-mtu 1500
switch(config-fabricpath-isis)#
|
|
---|---|
show fabricpath isis |
Displays FabricPath Layer 2 IS-IS. |