The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS FabricPath commands that begin with T.
To configure a Layer 2 topology for FabricPath Intermediate System-to-Intermediate System (ISIS), use the topology command. To return to the default setting, use the no form of this command.
Note Cisco Nexus 5000 series only supports 2 topologies; the default or base topology (topology 0), and the local VLAN topology (topology 1).
topology topology-number
no topology [topology-number]
topology-number |
Topology number. The range is form 1 to 63. |
None
FabricPath IS-IS configuration mode
|
|
---|---|
5.1(3)N1(1) |
This command was introduced. |
This command requires an Enhanced Layer 2 license.
This example shows how to configure a FabricPath IS-IS topology:
switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fabricpath domain default
switch(config-fabricpath-isis)# topology 1
switch(config-fabricpath-isis)#
|
|
---|---|
fabricpath domain default |
Enables FabricPath Layer 2 IS-IS. |